Flowline GT10 Series Thermo-FloTM Thermal Dispersion Air Flow Switch


The general purpose gas flow switch is a great choice for a broad range of relatively clean gases with non-coating characteristics. Media examples include nitrogen and scrubber exhaust fumes. The 1A relay provides a reliable switch interface with remote devices such as a PLC, SCADA or alarm. The short sensor is intended for use in pipe or ducting from 1/2” to 1-1/2”; the long sensor is applied in 2” and up. The switch set point may be adjusted from 1 to 90 fps. The product is broadly selected for low or no-flow applications.
Select a link under the "item" tab below to order.
Table 1 | Table 2 | Table 3 |
X | X | X |
Table 1 | Sensor material (1) |
1 | PP |
5 | PVDF |
Table 2 | Sensor length (2) |
3 | Short |
4 | Long |
Table 3 | Process mount (3) (4) |
0 | 3/4” NPT (US) |
2 | 3/4” G / Rp (Metric) |
Set point range | 1 to 90 fps (.3 to 27 mps) |
Factory set point | 10 fps (3 mps) |
Repeatability | ±.5% of set point @ fixed temp |
Response time | 1-10 seconds |
Set point adjust | Potentiometer |
Supply voltage | 12-36 VDC |
Consumption | 70 mA maximum |
Contact type | (1) SPST relay |
Contact rating | 60 VA |
Contact output | Selectable NO/NC |
Process temp | F: 32° to 140°
C: 0° to 60° |
Electronics temp | F: -40° to 140°
C: -40° to 60 |
Pressure | 150 psi (10 bar) @ 25° C., derated @ 1.667 psi (.113 bar) per °C. above 25° C |
Sensor rating | NEMA 4X (IP65) |
Sensor material | 1__5: PP-Ryton®
5__5: PVDF Kynar® |
Cable jacket mat. | 1__5: PP
5__5: PFA Teflon® |
Cable type | 4-conductor, #22 AWG (shielded) |
Cable length | Standard: 10’ (3m) Special order: 25’ (7.6m) or 50’ (15.2m) |
Process mount | 3/4” NPT (3/4” G / Rp) |
Mount. gasket | Viton® (G version only) |
Classification | General purpose |
CE compliance: | EN 50082-2 immunity
EN 55011 emission EN 61010-1 safety |