Honeywell S8910 Universal Hot Surface Ignition Module


Universal Hot Surface Ignition Module is designed to provide easy field replacement of a wide range of hot surface ignition modules manufactured by Honeywell, Robertshaw and White-Rodgers. The S8910U Module provides operating control of a direct ignition system using a 120 Vac hot surface igniter.
• Replaces many White-Rodgers, Robertshaw and Honeywell hot surface ignition models.
• For 120 Vac (up to 5.0A) surface igniter (Norton 201/271 or equivalent).
• For local (single rod) or remote (dual rod) rectification type flame sensing.
• Contains easy-to-use instructions plus the accessories required to adapt the existing hot surface ignition module.
• Provides one or three ignition trials (four-second or seven-second trials) per call for heat; prepurge of 32 seconds or less; up to 96 seconds between purge trial times.
• Temperature range is -40 to +175 F (-40 to +79 C).
Select a link under the "item" tab below to order.
Cat # | Pre Purge | Flame Failure Responce Time (sec) | Ignition Trial Time (sec) | Between Trial Time (sec) | Ignition Trials To Lockout | Lockout Timing |
S8910U1000 | 32 seconds | 1.5 sec. | 4 sec. or 7 sec. | (2) 96 sec.- 3 trial mode only | 1 or 3 | 4 sec. or 7 sec. |
Application | Provide electronic control of direct hot surface ignition systems used on gas fired furnaces, boilers, and other heating appliances |
Dimensions, Approximate | 5 1/4 in. high x 4 1/16 in. wide x 1 15/16 in. long (133 mm high x 103 mm wide x 49 mm deep) |
Type of Gas | Natural or LP |
Electrical Ratings | 24 Vac |
Frequency | 60 Hz |
Flame Sense | Single Rod or Two Rods |
Ignition Sequence | The number of trials for ignition and trial time is determined by the selection tab. If a selection tab is not installed, the module will operate at four seconds trial time and one ignition trial |
Ignition Source | Line Voltage (120 VAC) Hot Surface Element (Norton Model 201 or 270) |
Ignition System Type | Direct Hot Surface Ignition |
Maximum Valve Load @ 24 Vac (Amps) | 2A |
Typical Gas Control | VR8205, VR8305 |
Typical Ignition Hardware | Norton 201, Norton 271, Q354 |
Maximum Ambient Temperature | (-40 C to +79 C) -40 F to +175 F |
Approvals | Canadian Standards Association: Design Certified |