Jump to Navigation

Johnson Controls M9102 and M9104 Series Electric Non-Spring Return Actuators

Electric Non-Spring Return Actuators
M9102 and M9104 Series

Siemens introduces the newly expanded line of OpenAir Electronic Direct Coupled Damper Actuators with more torque, faster spring returns and more integrated features to save you time in installation, reduce operating costs, and provide unmatched reliability. OpenAir Damper Actuators meet your toughest application needs with the right solutions—even for fire and smoke damper specifications.

• two torques available: 18 and 35 lb·in (2 and 4 N·m) — offer the most suitable choice for the specific application
• short 30-second travel time available — provides a quick response for two-position zone applications
• 35 dBA nominal audible noise rating — meets the audible noise requirements for open ceiling environments
• synchronous drive — provides a constant rotation time that is independent of the load
• 100,000 cycle rating — provides years of trouble-free service
• direct shaft mounting with single-screw coupler — reduces installation time and provides three-point shaft gripping
• magnetic clutch — protects the actuator gear train and the damper from damage due to excessive torque during a stall condition
• manual gear release — simplifies actuator setup and adjustments in the field
• plenum cable or screw terminal electric connections — make wiring quick and easy
• floating, floating with timeout, and proportional 0(2)...10 VDC control inputs available — offer a full range of control input options
• small, compact design — allows installation in tight-fitting locations

Select a link under the "item" tab below to order.

Cat #Electrical ConnectionsControl TypeRunning TorqueTravel Time
M9102-AGA-2S48 in. (1.2 m) UL 444 Type CMP Plenum Rated cable with 19 AWG (0.75 mm2) conductors and .25 in. (6 mm) ferrule endsFloating18 lb·in (2 N·m)30 Seconds at 60 Hz
M9102-AGA-3SM3 Screw TerminalsFloating18 lb·in (2 N·m)30 Seconds at 60 Hz
M9104-AGA-2S48 in. (1.2 m) UL 444 Type CMP Plenum Rated cable with 19 AWG (0.75 mm2) conductors and .25 in. (6 mm) ferrule endsFloating35 lb·in (4 N·m)60 Seconds at 60 Hz
M9104-AGA-3SM3 Screw TerminalsFloating35 lb·in (4 N·m)60 Seconds at 60 Hz
M9104-IGA-2S48 in. (1.2 m) UL 444 Type CMP Plenum Rated cable with 19 AWG (0.75 mm2) conductors and .25 in. (6 mm) ferrule endsFloating or On/Off35 lb·in (4 N·m)60 Seconds at 60 Hz
M9104-IGA-3SM3 Screw TerminalsFloating or On/Off35 lb·in (4 N·m)60 Seconds at 60 Hz
M9104-GGA-2S48 in. (1.2 m) UL 444 Type CMP Plenum Rated cable with 19 AWG (0.75 mm2) conductors and .25 in. (6 mm) ferrule endsProportional35 lb·in (4 N·m)60 Seconds at 60 Hz
M9104-GGA-3SM3 Screw TerminalsProportional35 lb·in (4 N·m)60 Seconds at 60 Hz
Product M9102-AGA-2S, -3S and M9104-xGA-2S, -3S Series Electric Non-Spring Return Actuators
Power Requirements M910x-AGA-xS AC 24 V +25%/-20% at 50/60 Hz, 2.1 VA Supply, Class 2, Safety Extra-Low Voltage (SELV)
M9104-IGA-xS AC 24 V +25%/-20% at 50/60 Hz, 3.0 VA Supply, Class 2, SELV
M9104-GGA-xS AC 24 V +25%/-20% at 50/60 Hz, 3.6 VA Supply, Class 2, SELV
Control Type M910x-AGA-xS Floating Control without Timeout
M9104-IGA-xS Floating or On/Off Control with Timeout
M9104-GGA-xS Proportional Control
Input Signal M910x-AGA-xS AC 24 V +25%/-20% at 50/60 Hz, Class 2, SELV without Timeout
M9104-IGA-xS AC 24 V +25%/-20% at 50/60 Hz, Class 2, SELV with Timeout
M9104-GGA-xS 0(2) to 10 VDC or 0(4) to 20 mA with field-furnished 500 ohm resistor
Feedback Signal M9104-GGA-2S 0 to 10 VDC or 2 to 10 VDC for 90° (10 VDC at 1 mA)
Corresponds to input signal span selection
Motor Input Impedance 200 ohms Nominal
Running Torque M9102 Series 18 lb·in (2 N·m)
M9104 Series 35 lb·in (4 N·m)
Travel Time M9102 Series 30 Seconds at 60 Hz (36 Seconds at 50 Hz) for 90° of Rotation
M9104 Series 60 Seconds at 60 Hz (72 Seconds at 50 Hz) for 90° of Rotation
Rotation Range 93° ± 3°, CW or CCW
Cycles 100,000 Full Stroke Cycles;
2,500,000 Repositions at Rated Running Torque
Audible Noise Rating 35 dBA Nominal at 39-13/32 in. (1 m)
Electrical Connections M9102-AGA-2S
M9104-xGA-2S
48 in. (1.2 m) UL 444 Type CMP Plenum Rated Cable with 19 AWG (0.75 mm2) conductors and
.25 in. (6 mm) ferrule ends
M9102-AGA-3S,
M9104-xGA-3S
M3 Screw Terminals
Mechanical Connections Up to 1/2 in. (13 mm) Diameter Round Damper Shaft or 3/8 in. (10 mm) Square Damper Shaft
Enclosures M9102-AGA-2S
M9104-xGA-2S
NEMA 2, IP42
M9102-AGA-3S,
M9104-xGA-3S
NEMA 1, IP40
Ambient Conditions Operating -4 to 140°F (-20 to 60°C); 90% RH Maximum, Noncondensing
Storage -20 to 150°F (-29 to 66°C); 90% RH Maximum, Noncondensing
Compliance North America UL Listed, File E27734, CCN XAPX (United States) and XAPX7 (Canada)
European Union CE Mark, EMC Directive 89/336/EEC
Australia and New
Zealand
C-Tick Mark Australia/NZ Emissions Compliant
Shipping Weight 1.0 lb (0.5 kg)


Main menu 2

about seo