Jump to Navigation

Fireye E110 Flame-Monitor™

Flame-Monitor™
E110

The Fireye® E110 FLAME-MONITOR™ System is a microprocessor based burner management control system designed to provide the proper burner sequencing, ignition and flame monitoring protection on automatically ignited oil, gas, and combination fuel burners. In conjunction with limit and operating controls, it programs the burner/blower motor, ignition and fuel valves to provide for proper and safe burner operation. The control also provides current operating status and lockout information in the event of a safety shutdown. The manner in which this information is displayed is dependent on the type of programmer (EP or EPD) and display module (ED510 or ED500).* Refer to Flame-Monitor PROGRAMMER SELECTION later in this document for the various combinations of programmer and display modules.

  • A non-volatile memory which allows the control to remember its history and present position even when power is interrupted.
  • A constant flame signal read-out via display module or 0-10 VDC output (EPD programmers only).
  • Read-out of main fuel operational hours and complete cycles via display module.
  • Modbus communications via RS485 multi-drop link.
  • Dipswitches located on the EP programmer to allow selectable purge time.
  • A run/check switch which allows the operator to stop the program sequence in any of three different positions (Purge, PTFI, or Auto).
  • Remote Display Capability.
  • Annunciate 16 additional interlocks using E300 Expansion Module.

Select a link under the "item" tab below to order.

Cat #Flame Monitor Chassis
E110Control, consisting of EB700, 48-1836, EC600. 120 VAC. UL, FM, UL/c Approved.


Main menu 2

about seo